Skip to content

Gweike G2 20W vs G2 Max 50W

Compare the 150 × 150 mm electric-lift packages. One reviewer used both power levels for brass coin relief and separately tried cutting stainless shim stock on the Max.

Research byResearch updatedResearch method

Which should you shortlist?

Start with the G2 20W for surface IDs and shallow marks. Consider the 50W Max if brass relief is a regular job. Time the same artwork on the same alloy to your required depth so you can judge how much time the upgrade would save.

Gweike G2 20W vs G2 Max 50W
Gweike G2 20WGweike G2 Max 50W
Seller configurationG2 20W Metal & Plastic Fiber Laser Engraver / Electric Lift ( 150*150mm field lens )+ Safety ShieldG2 Max 50W fiber, 150 x 150 mm
Rated power20 W50 W
Published marking field150 × 150 mm with electric lift150 × 150 mm with electric lift
Laser source type20W fiber50W fiber
Useful sampleA finished metal tag or a brass blankThe same blank and a target relief depth
Seller price$1,349Checked View sellerCheck with sellerView seller
Specification sourceGweike G2 20W ↗Gweike G2 Max 50W ↗

Is the 20 W configuration enough?

Use the G2 as the first quote for tags and shallow metal marks when legibility, finish and batch size are the main requirements. Compare the Max when relief depth, repeated passes or production capacity materially affects job costs. Both published fields in this comparison are the same size.

How do you compare output on the same material?

Use the same blank, design, target depth and finish on both. Measure the depth and record the elapsed time to the accepted result. Include cleaning, setup and rework in the batch timing. A quick mark on a different alloy is weak evidence for a paying job.

What package differences should you verify?

Check the included lift, fixtures, guards and accessories on the selected seller variants. Quote extraction and enclosure separately if required by your site. Ask for a written list of what shipped with the test configuration.

Video tests

G2 20W vs G2 Max 50W on brass coin relief

Test conditions
The reviewer compared deep brass coin engraving on the original 20W G2 and the 50W G2 Max, using LightBurn 3D Slice on the Max.
Observed result
The reviewer reported a deeper result in about half the time on the Max. The video gives no matched set of settings or measured depths for the two runs.

Gweike supplied the G2 Max. The reviewer disclosed affiliate links.

Watch on YouTube · Hoffman Engineering · 7:37 ↗

G2 Max 50W cut-through and heat warp

Test conditions
G2 Max 50W on 0.13 mm stainless steel shim stock.
Observed result
Four passes cut through with a clean edge in this test. The thin stock warped from the heat.

Gweike supplied the G2 Max. The reviewer disclosed affiliate links.

Watch on YouTube · Hoffman Engineering · 8:30 ↗