xTool F2 Ultra MOPA vs F2 Ultra UV
Compare the F2 Ultra Dual MOPA package with the F2 Ultra UV. Start with the metal relief depth, transparent surface or plastic marking contrast you need.
Research byPickaLaserResearch updatedResearch method
Which should you shortlist?
Consider MOPA for deep metal engraving or stainless colour work. Test the UV model for transparent materials or fine marks on plastics. The same laser can give very different contrast on two colours of PLA, so send your exact material and colour for a sample.
| xTool F2 Ultra Dual | xTool F2 Ultra UV | |
|---|---|---|
| Seller configuration | xTool F2 Ultra 60W MOPA & 40W Diode Dual Laser Engraver / Dual Laser (60W MOPA & 40W Diode) / F2 Ultra Standalone | xTool F2 Ultra UV 5W UV Laser Engraver / F2 Ultra UV Standalone |
| Rated power | Check with seller | 5 W |
| Laser sources | 60W MOPA fiber + 40W diode | 5W UV |
| Standard surface field | 220 × 220 mm | 200 × 200 mm |
| Sample to compare | Your metal alloy and target engraving depth | Your exact glass, acrylic or polymer and required finish |
| Seller price | $5,299Checked View seller | $4,299Checked View seller |
| Specification source | xTool F2 Ultra Dual ↗ | xTool F2 Ultra UV ↗ |
Which materials should decide the shortlist?
Put your highest-volume material first. Quote the MOPA/Dual package for metal jobs with a defined depth or a specific finish. Quote the UV configuration for glass or polymers where edge quality, mark contrast or surface appearance matters. Test each production material separately because results on one grade do not transfer to another.
What makes a sample pass?
Give the seller a target depth, minimum legible lettering and a finish reference. For glass or polymers, inspect the smallest detail and compare debris and surface changes at the edges. Use the same artwork and assess the sample under the lighting used for final inspection.
What should you confirm about the work envelope?
Ask which lens and accessory set is included. A published surface field does not determine clearance for a raised or rotating part. Check clearance and alignment with the real fixture before using a sample from a flat part to make a buying decision.
Video tests
Reflective coins on the F2 Ultra Dual conveyor
- Test conditions
- The reviewer ran eight reflective coins in automatic production mode with a circular design that had to align with the edge.
- Observed result
- Six met the reviewer’s saleability standard. One was skipped and one was visibly off-center. In a separate eight-coin batch on the work bed, with alignment checked before engraving, the reviewer reported all eight aligned.
The video description discloses affiliate links.
Watch on YouTube · Chad’s Custom Creations · 3:02 ↗60W MOPA and 5W UV mark the same printed part
- Test conditions
- The reviewer tuned both lasers on light grey Bambu Lab PLA, then marked printed SMD component holders. Black PLA holders were also tried.
- Observed result
- The grey samples were usable, but both fell short of the UV-printed reference. The UV laser gave nearly white, high-contrast marks on the black PLA in this test.
xTool supplied the machines and sponsored the video.
Watch on YouTube · CNC Kitchen · 25:08 ↗Clear acrylic surface engraving after refocusing
- Test conditions
- F2 Ultra UV 5W with the surface lens on a 150 × 100 mm clear acrylic piece.
- Observed result
- The first attempt was only sharp in parts of the field. After the reviewer lowered the focus point by about 1 mm, the second run took about 33 minutes and appeared sharp across the design.
xTool supplied the machine and sponsored the video.
Watch on YouTube · Aurora Tech · 20:36 ↗