LightBurn Forum · Owner setup guide
Chuck and roller settings need different checks
The author describes using an RA2 Pro chuck and an Atezr roller on Sculpfun machines, checking a full revolution, entering diameter and measuring the finished result. It is a useful setup procedure, not one set of values to copy.
First-person setup guide. Motor steps, roller diameter and object diameter depend on the machine and rotary being configured.
Read original guide: Chuck and roller settings need different checks ↗LightBurn Forum · Owner-reported case
A stalling case spans two chuck models
A D1 Pro user reports intermittent stopping with both an RA2 and a YRC 1.0. Replies suggest checking the drive system and acceleration, but the thread does not establish a final cause.
One user and one connected engraver. This is not evidence of a failure rate for either rotary.
Read original source: A stalling case spans two chuck models ↗xTool Support · Manufacturer guidance
xTool explains why the machine and firmware matter
xTool's D1-series support guidance distinguishes D1 from D1 Pro and chuck mode from roller mode. Compatibility should be checked against the machine, firmware and control software together.
Manufacturer support document from 2023. Do not apply its D1 settings to newer P2, F2 or RA3 hardware.
Read original guide: xTool explains why the machine and firmware matter ↗