Reddit · Owner-reported case
Metal-spray users compare marking and cleanup
Users report good stainless-steel results with LMM6000 and LaserBond. One prefers Brilliance for easier residue removal; another could not get the red OMTech spray to mark with a 10W Ortur diode.
Different formulas, lasers and settings were used. The red-spray failure is a 10W-diode case, outside its listed CO2/fiber use; it does not establish a general failure rate.
Read original source: Metal-spray users compare marking and cleanup ↗Reddit · Owner-reported case
Good marks, with different experiences of the can
Users describe clear Brilliance marks after rinsing and durable LaserBond results. Blackdragon1400 reports a failed Brilliance can and prefers OMTech. Cleanup and nozzle operation matter alongside the final mark.
A mixed community discussion, not a controlled comparison. Formula and package sizes are not consistently identified.
Read original source: Good marks, with different experiences of the can ↗Amazon seller listing · Seller specifications · not an owner review
Ink preparation differs from aerosol preparation
The 50 g bottle instructions call for denatured alcohol: at least 1:1 for brush use or 2:1 for an airbrush or spray gun. The aerosol comes ready to spray. A lower bottle price does not mean the same ready-to-use volume or equipment.
Seller instructions for the 50 g ink. The community reports below discuss LaserBond marking results without establishing the bottle form or its coverage.
Read original source: Ink preparation differs from aerosol preparation ↗